Fan and Wing Mount Plaque

This item does require some work to attach the turkey parts. It does not come with instructions, but I will explain how to attach here.. It comes ready to accept your turkey fan into the slot behind the plaque. Hot glue cardboard spacers onto the back of your fan to ensure a tight fit.

It doesn’t have the burnt track. If you want the burnt track please choose another listing. Display picture is assumed if no message is received.

A spacer is added to the back to allow room for the wings to be screwed directly to the back of plaque. I typically use 1 1/4” screws and put 2 screws through the wing bone. Be sure to pre-drill and have the wings where you want them before drilling.

The legs can be hot glued, brad nailed, or screwed directly to the plaque. Remove front plaque, pre-drill 1/8” through tops of leg and into plaque, then using a 1 1/4” screw tighten the legs down on each side of the spacer block.

With the beard I usually pop out the primer of the shotgun shell and drill a hole in the center of the spacer provided (1/8” bit). Then I will use 1" screw and screw the shot gun shell to the spacer. Once in place I will fill the shotgun brass with hot glue and insert beard.

Contact me if you have any questions.

This item is available in burnt pine, stained pine, and barnwood.

Barnwood will vary, and may be more brittle due to aged wood.